Otherwise, you can perform a hardware reset by toggling the XBee 3s reset pin.However, this can apply to the XBee Series 3 module as long as you configure the firmware to the legacy 802.15.4 protocol.For more information, read through this guide.
![]() And theyre highly configurable -- you can have meshed networks with dozens of XBees, or just a pair swapping data. You can use them to remotely control your robot, or arrange them all over your house to monitor temperatures or lighting conditions in every room. In most cases youll want a separate module to interface with the XBee. You can use an XBee Shield to connect an XBee to your Arduino. Or you can use an XBee Explorer to connect an XBee to your computer. There are a variety of Explorer boards, all designed to achieve the same purpose: to create a communication gateway between your computer and the XBee. Digi Xbee Software How To Do AllWere going to show you how to do all of that in this tutorial. They need buddies to talk to Hence, theres a lot of 2x in this list of materials. To follow along with this tutorial, you will need the following materials. You may not need everything though depending on what you have. Add it to your cart, read through the guide, and adjust the cart as necessary. If youre just getting started with XBee, we highly recommend going with Series 1 (or Series 3 configured with the 802.15.4 protocol) models with a built-in antenna -- either with a trace antenna, wire antenna. You can also get one with a u.fl connector but you will need to get the appropriate external antenna. Theyre used to configure your XBee and pass data to and from your computer. If youre curious about other XBee classes, check out this guide. If youre not familiar with the subjects below, we recommend checking out those tutorials first. This tutorial will get you familiar with terms like RX, TX, baud rates, stop bits, and parity. You can use your preferred terminal instead; if you dont have a preferred serial terminal, check out this tutorial. They modules are drop-in replacements for Series 1 and Series 2 with a few exceptions. Below are two of those exceptions taken out of the migration guide and hardware reference manual. As indicated in the hardware reference manual, you should not connect to this pin on boards labeled with VREF. The hardware reference manual indicates that: Parts with an early revision of the microcontroller unit (MCU) may experience an issue.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. Archives
December 2020
Categories |